WAN Cable. The WAN cable that is used to connect your router and modem can be a normal ethernet cable.
I recommend using a CAT5e or CAT6 cable for the connection.
Why is my Wi-Fi better than Ethernet
Why is that? Your Wifi speed can be higher than ethernet if there are issues with your ethernet connection like cable damage, outdated NIC driver, etc. If your ethernet equipment is of low quality, it will reduce your internet speed.
So, even though ethernet is usually faster, sometimes your WiFi can surpass it.
What is CBS and EBS
1. Specifies the maximum number of bits allowed for incoming Service Frames to be EIR-conformant; for every connection, an EBS is defined.
It is also defined as the maximum number of bits in excess of the Committed Burst Size (CBS) that a user can send during a predefined time period.
Does Australia have gigabit internet
Ultrafast internet, as dubbed by the NBN, is officially the fastest NBN available in Australia maxing out at potential speeds of 1000Mbps.
Gigabit NBN!?
Does router matter if you use Ethernet
In your case it will make no difference. If you were connecting to a gigabit fiber connection then there could be a small chance.
Some older routers did not have the cpu capacity to keep up with these fast connection.
Why my Ethernet is slower than WiFi
The reason is that an Ethernet cable directly connects your router to your computer or other device using the Internet, and Wi-Fi uses radio waves.
With Wi-Fi, there are many instances where interference and distance can slow down the connection.
What is CIR Internet connection
Committed information rate (CIR) is the guaranteed rate at which a Frame Relay network will transfer information under normal line conditions.
In Frame Relay networks, CIR refers to the bandwidth associated with a logical connection in a permanent virtual circuit (PVC).
What is cat5 Cat6 and Cat7 cable
Cat5e – Has a speed up to 1.000 Mbit/s, 100MHz. Cat6 – Has a speed up to 1.000 Mbit/s, 250MHz.
Cat6a – Has a speed up to 10.000 Mbit/s, 500MHz. Cat7 – Has a speed up to 10.000 Mbit/s, 1.000MHz.
What is Australia’s fastest internet?
- Vodafone performed at 95.1% of its maximum plan speed
- Aussie Broadband performed at 94.8% of its maximum plan speed
- iiNet performed at 94.8% of its maximum plan speed
- Superloop performed at 94.3% of its maximum plan speed
- MyRepublic performed at 98.0% of its maximum plan speed
Should I use Ethernet or WiFi for gaming
WiFi, an Ethernet connection is the best choice for incredible download speeds. Most modern gaming devices take advantage of a 5GHz wireless connection.
Still, you will experience a slower speed than Ethernet, even if it’s just a few Mb/s.
Go with a wired connection if your gaming setup allows for it.
Is FTTN better than HFC
HFC vs FTTN: Speeds In the ACCC broadband speed test, HFC delivered approximately 86% of the maximum plan speed during busy hours.
In contrast, FTTN provided approximately 78% of the maximum plan speed during the same busy hours.
Should I connect Ethernet to modem or router
Connect your router to your modem using an Ethernet cable. Most routers have multiple Ethernet ports, but there’s one specifically labeled “Internet” or “WAN” (wide area network) used for connecting directly to the modem.
What is the difference between FTTN and FTTH
Differences Between FTTN and FTTH FTTN providers run fiber lines to a central node, and then from there through existing copper or coaxial lines to the customer (think AT&T U-verse).
FTTH providers, on the other hand, run fiber lines directly to the consumer’s home, meaning there is no “last mile” (think Verizon Fios).
Is FTTP better than FTTN
Long-term policy considerations. FTTC and FTTP are generally considered superior to FTTN because they are faster, with a longer life cycle.
They also have lower maintenance costs compared to FTTN, although NBN Co incurs these costs, not the consumer.
Which wholesale traffic classes have a committed information rate CIR )
Traffic Classes TC1, TC2 & TC4 TC1 is primarily used to support voice services, specifically Voice over IP (VoIP), and is designed to provide access to the following features: A Committed Information Rate (CIR) at the wholesale level – designed to support voice communication quality.
Which wholesale traffic class is suitable for general Internet data ie web browsing and email
Traffic Class 4 (TC-4) TC-4 is known as the “best effort” traffic class for non-critical applications ranging from email and streaming to web browsing.
Why am I not getting full 1gb internet speed
It’s possible that the computer or device you’re using to connect to the Internet is simply not built to handle a fast wireless network.
From your Internet provider to your device, your speeds will only be as fast as the weakest, or slowest, link.
What type of router do I need for FTTP
Any of DrayTek’s latest routers, such as the Vigor 2927, Vigor 2765, Vigor 2865 and Vigor 2866 can be connected to full-fibre broadband, with up to 950mbps of Hardware Accelerated Firewall throughput.
This article explains how to setup your DrayTek router to connect to your Ultrafast FTTP service.
Is FTTP better than FTTC
Is FTTP better than FTTC broadband? Absolutely, yes. FTTP is capable of far higher speeds and typically also offers symmetrical speeds where your upload speed is the same as your download speed.
FTTC on the other hand has a much lower speed ceiling and upload speeds are typically a fraction of download speeds.
Is fibre to the node better
NBN says average FTTN speeds 10 times faster than ADSL “Fibre-to-the-node is able to provide average wholesale download speeds of about 70Mbps.
This is approximately 10 times faster than average ADSL speeds in Australia,” an NBN spokesperson said.
What is a BNTD
Business Network Termination Device (BNTD) equipment location guide. Location. The Ideal location for a Business Network Termination Device (BNTD) is a server room or communications room.
Which is better fibre to the node or curb
FTTC vs FTTN: Speed Fibre to the Curb (FTTC) and Fibre to the Node (FTTN) are two different ways to deliver internet to your home.
Both utilise the same copper cable network for delivery of cable internet and pay TV services like Foxtel.
While FTTC has a faster speed and can cope with high rates, FTTN is slower.
Do I need special router for FTTP
FTTP/C, HFC Service Types In this case, you will simply need an eWAN (Ethernet Wide-Area-Network) WiFi Router (there is no need for a modem component).
You can supply and connect your own hardware as long as it isn’t locked to your current or previous internet service provider, and that it is nbn™ compliant.
What is TC2 and TC4
THE THREE TRAFFIC CLASSES ARE: TC2 also offers low latency, jitter and loss characteristics.
Traffic Class 4 (TC4) – primarily for general internet and standard data services, including residential connections.
Upload speed is significantly slower than download speed, and latency, jitter and loss is higher.
Is Cat 7 better than Cat6
CAT 7 Ethernet cables support higher bandwidths and much faster transmission speeds than Cat 6 cables.
As a result they are much more expensive than their Cat 6 counterparts, however, if you are looking for better performance, they are worth the extra cost.
Cat 7 cables can reach up to 100 Gbps at a range of 15 meters.
How can I check my Internet bandwidth?
- Connect to your computer to your router using an Ethernet cable
- Open your web browser
- Navigate to www.speedtest.net
- Tap “Go.”
How much does it cost to run cat6 cable in house
Upgrading to CAT-6 cable provides the speed and reliability needed for your home or business Internet and networking needs.
The national average cost of CAT-6 installation is $2,000 to $5,000, with most people paying about $3,800 for 2,000 feet of CAT-6 cable and eight drops professionally installed.
Can I use VDSL modem for VDSL2
So no, it would not work, as ADSL, ADSL2 and VDSL are all different standards on the same family of technology, DSL.
Can I use my own router with FTTP
You may continue using your own router. You don’t need the modem as the FTTP ONT is the modem.
What is low cost strategy
A pricing strategy in which a company offers a relatively low price to stimulate demand and gain market share.
Citations
https://superloop.com/blog/nbn-for-business-part-1-key-facts-and-terms-explained/
https://www.canstarblue.com.au/internet/nbn-connection-types/
https://www.aussiebroadband.com.au/blog/nbn-need-know-traffic-service-classes/
https://www.cox.com/residential/internet/guides/internet-speed-guide/wifi-vs-ethernet.html
